Protek RC 5550 1S 3.7V 5500mAh High Capacity Sanwa M17 LiPo Transmitter Battery

Description: Protek RC 5550 1S 3.7V 5500mAh High Capacity Sanwa M17 LiPo Transmitter Battery Protek RC 5550 1S 3.7V 5500mAh High Capacity Sanwa M17 LiPo Transmitter Battery This is the ProTek R/C High Capacity 1S Transmitter Battery with 5500mAh of capacity, for use with the Sanwa M17 Surface Transmitter. This light weight Li-Poly transmitter battery will help to dramatically extend the run time that your transmitter can offer, which is great for long days at the field! How should the battery be inserted into the transmitter? A suitable foam should be used to pad the battery in the transmitter battery compartment to help hold the battery in place and prevent it from moving around. Place a piece similar in size to the battery into the transmitter battery housing under the battery, and then while pressing lightly on the battery, slide the cover over the battery. Specifications: Voltage: 3.7V Capacity: 5500mah Chemistry: Lithium Polymer Connector: JR Charge Rate: 1C Dimension (LxWxH): 79x46.5x12mm Weight: 94g IMPORTANT: DO NOT leave the battery in your model when charging DO NOT leave unattended when charging ALWAYS balance charge the battery ALWAYS use a LiPo charging bag YOU MUST use a Li-Poly specific charger to charge the pack (NiMH or NiCD only chargers WILL NOT WORK!) YOU MUST not over discharge the Li-Poly battery pack READ & UNDERSTAND the instructions carefully before operating this battery NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in over heated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use the battery that has too low a voltage. Do not expose batteries to sunshine or store/charge batteries at the temperature above 35°C or in a closed car. The high temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging or racing, do not charge the battery until it has cooled completely. Wait about 20 mins, then inspect prior to recharging. Protek RC 5550 1S 3.7V 5500mAh High Capacity Sanwa M17 LiPo Transmitter Battery Protek RC 5550 1S 3.7V 5500mAh High Capacity Sanwa M17 LiPo Transmitter Battery This is the ProTek R/C High Capacity 1S Transmitter Battery with 5500mAh of capacity, for use with the Sanwa M17 Surface Transmitter. This light weight Li-Poly transmitter battery will help to dramatically extend the run time that your transmitter can offer, which is great for long days at the field! How should the battery be inserted into the transmitter? A suitable foam should be uséd to pad the battery in the transmitter battery compartment to help hold the battery in place and prevent it from moving around. Place a piece similar in size to the battery into the transmitter battery housing under the battery, and then while pressing lightly on the battery, slide the cover over the battery. Specifications: Voltage: 3.7V Capacity: 5500mah Chemistry: Lithium Polymer Connector: JR Charge Rate: 1C Dimension (LxWxH): 79x46.5x12mm Weight: 94g IMPORTANT: DO NOT leave the battery in your model when charging DO NOT leave unattended when charging ALWAYS balance charge the battery ALWAYS use a LiPo charging bag YOU MUST use a Li-Poly specific charger to charge the pack (NiMH or NiCD only chargers WILL NOT WORK!) YOU MUST not over discharge the Li-Poly battery pack READ & UNDERSTAND the instructions carefully before operating this battery NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in over heated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell). Do not use the battery that has too low a voltage. Do not expose batteries to sunshine or store/charge batteries at the temperature above 35°C or in a closed car. The high temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging or racing, do not charge the battery until it has cooled completely. Wait about 20 mins, then inspect prior to recharging. × Buy now and save! Shipping info Click the Shipping & Payments tab above the listing description for more info Click the Shipping & Payments tab above the listing description for more info! Additional delivery notes PICK UP OPTION Sorry, our items are NOT available for pick-up. PAYMENT Immediate payment is required upon selecting "Buy It Now" or upon checking out through the cart. We accept payment via U.S. PayPal accounts and all Major Credit Cards, Debit Cards & Google Pay. We are legally required to collect sales tax in those states and localities where we maintain a physical presence (nexus). The applicable amount of sales tax charged to an order will be calculated based on the shipment destination's state and local sales tax laws. Thank you for shopping with us on eBay! Additional Information No additional information at this time Ask seller a question You might also like Atlas Trainman 20006500 HO Scale ACF 3560 Covered Hopper Cancarb ACFX 74072 Atlas Trainman 20006504 HO Scale ACF 3560 Covered Hopper Chessie System 601322 Atlas Trainman 20006505 HO Scale ACF 3560 Covered Hopper Chessie System 601343 Lionel 2228150 O Gauge 2022 Christmas Boxcar Contact To contact our Customer Service Team, simply click the button here and our Customer Service team will be happy to assist. Ask seller a question © White Rose Hobbies Shipping & Payments Click the Shipping & Payments tab above the listing description for more info Payment Accepted Payment Methods Immediate payment is required upon selecting "Buy It Now" or upon checking out through the cart. We accept payment via U.S. PayPal accounts and all Major Credit Cards, Debit Cards & Google Pay. We are legally required to collect sales tax in those states and localities where we maintain a physical presence (nexus). The applicable amount of sales tax charged to an order will be calculated based on the shipment destination's state and local sales tax laws. Thank you for shopping with us on eBay! Returns Returns are accepted Items must be returned within 30 days of the auction ending Buyer will pay for return shipping. eBay integration by

Price: 52.99 USD

Location: York, Pennsylvania

End Time: 2024-02-09T19:53:24.000Z

Shipping Cost: N/A USD